The Ford Probe is a home car designed to fit in with the import car scene. The design and efficiency of the Ford Probe, along with the variety of aftermarket parts, allows home car fans to drive a Ford that looks right at home with most other sport compact cars. Body kits obtainable for a Ford Probe add model and a extra dramatic look. You can set up a Ford Probe body equipment in around two hours using frequent tools.

Ford Probe Body Kit Installation Instructions

1. Take away the manufacturing unit entrance bumper. Take away the entrance bumper by opening the hood. Remove the three bolts along the top of the bumper using the ratchet and 10 mm socket. Remove the row of 10 mm bolts along the underside fringe of the front bumper. Remove the Phillips screws in the rear edge of the bumper after which pull the bumper off.
2. Take off the rear bumper. Open the trunk and take away the row of 4 bolts along the highest of the rear bumper. Take away the screws alongside the front fringe of the rear bumper, immediately behind the rear tires. Pull the bumper off.
3. Remove the facet skirts if the physique package has replacements for the facet skirts within the kit. Most Ford Probe body kits do not supply facet skirts, although a number of do. Take away the two 12 mm bolts from either side skirt. There may be one bolt close to the front and one bolt near the rear, underneath the aspect skirts.
4. Place the entrance bumper of the body kit on the Probe. Install the three 10 mm bolts along the top of the bumper to hold it in place. Install the screws along the rear edge of the entrance bumper of the physique kit, simply in front of the entrance tires. Change the 10 mm bolts alongside the underside of the front bumper in the body kit.
5. Sit the rear bumper of the physique equipment on the rear of the Ford Probe. Install and tighten the row of bolts alongside the highest edge of the bumper. Use a Phillips screwdriver to insert the screws alongside the entrance fringe of the rear bumper.
6. Place the side skirt alongside the facet of the Probe and insert one bolt at a time. Once each bolts are in place, tighten them completely.